1Obtain a TP roll or cardboard can.

Start out with a toilet paper roll. If it's a bit small for your wrist or arm, use a cardboard can such as a small Pringles can or shoestring potato can. Cut off the can's base.

2Make a slit on the TP roll.

Cut the TP roll or cardboard can along its height. The slit will allow you to wear the roll on your wrist or arm.

3Trim the TP roll.

Trim the TP roll or cardboard can to the desired length of your bracelet or armband.

4Try on the bracelet.

Try it on. You can further trim it down until you achieve the desired bracelet or armband length.

5Roll strips of paper.

Create embossing or raised features on your bracelet by gluing materials such as paper, yarn or jute twine. Roll and twist paper tightly into a pair of 6 to 8-inch long strips.

6Decorate the edges of the bracelet.

Glue the pair of rolled paper strips, yarn, or jute twine at the top and bottom edge of the bracelet. Trim any excess length.

7Add more details.

Decorate the middle part of your bracelet by gluing yarn or twine to create straight, wavy or zigzag lines. Add small details by gluing seeds, beans, little stones, or tiny bits of paper rolled into balls.

Use tacky glue instead of regular white glue for attaching heavier materials like beans and small stones.

8Paint with a primer.

Once the glue dries, prime the entire surface of the bracelet with white acrylic paint. Allow the paint to dry completely.

9Paint it gold.

Paint the entire surface of the bracelet with gold acrylic or poster paint.